 |
 |
 |
 |
 |
 |
 |
 |
 |
B.51 LeCroy Digitizing Oscilloscope 9424E
Module name: lecroy9424e
Description: LeCroy Digitizing Oscilloscope 9424E, 4 measurement channels, 2 function channels (needed for averaging), 2 memory channels, 350 MHz bandwidth. It is mostly identical to the LeCroy9424, but the fourth channel can't be used as a trigger input and the device has an external trigger input instead.
Controlled via: GPIB bus (IEEE 488).
In the GPIB configuration file use "LECROY9424E" as the device name,
'\n' or 0xa as the EOS character, set set-reos and
set-xeos to no and set-bin and set-eot to
yes.
Status: Similar module for LeCroy 9450 works
Supported functions:
- `digitizer_name()'
- `digitizer_define_window()'
- `digitizer_change_window()'
- `digitizer_window_position()'
- `digitizer_window_width()'
- `digitizer_timebase()'
- `digitizer_interleave_mode()'
- `digitizer_time_per_point()'
- `digitizer_sensitivity()'
- `digitizer_offset()'
- `digitizer_coupling()'
- `digitizer_bandwidth_limiter()'
- `digitizer_trigger_channel()'
- `digitizer_trigger_level()'
- `digitizer_trigger_slope()'
- `digitizer_trigger_coupling()'
- `digitizer_trigger_mode()'
- `digitizer_trigger_delay()'
- `digitizer_averaging()'
- `digitizer_num_averages()'
- `digitizer_record_length()'
- `digitizer_trigger_position()'
- `digitizer_meas_channel_ok()'
- `digitizer_start_acquisition()'
- `digitizer_get_curve()'
- `digitizer_get_area()'
- `digitizer_get_amplitude()'
- `digitizer_run()'
- `digitizer_copy_curve()'
|
|
|
|
|
This document was generated by Jens Thoms Toerring on September 6, 2017 using texi2html 1.82.