 |
 |
 |
 |
 |
 |
 |
 |
 |
B.55 LeCroy Digitizing Oscilloscope WaveSurfer
Module name: lecroy_ws (LAN version) or
lecroy_ws_g (GPIB version)
Description: LeCroy Digitizing Oscilloscope WaveSurfer, models 422, 424, 432, 434, 452 and 454 (the model must be set in the configuration file). 2 or 4 measurement channels (depending on model), 1 function channel, 4 memory channels.
Controlled via: LAN (LeCroy VICP protocol, module lecroy_ws)
The IP address of the device (or its hostname if it has a DNS entry)
must be set in the configuration file for the device
`config/lecroy_ws.conf'.
or
Controlled via: GPIB bus (IEEE 488) (module lecroy_ws_g)
In the GPIB configuration file use "LECROY_WS_G" as the device name,
'\n' or 0xa as the EOS character, set set-reos and
set-xeos to no and set-bin and set-eot to
yes.
Status: Tested with at least one of the models and LAN control
paragraphindent 0 Supported functions:
- `digitizer_name()'
- `digitizer_define_window()'
- `digitizer_change_window()'
- `digitizer_window_position()'
- `digitizer_window_width()'
- `digitizer_timebase()'
- `digitizer_interleave_mode()'
- `digitizer_time_per_point()'
- `digitizer_sensitivity()'
- `digitizer_offset()'
- `digitizer_coupling()'
- `digitizer_bandwidth_limiter()'
- `digitizer_trigger_channel()'
- `digitizer_trigger_level()'
- `digitizer_trigger_slope()'
- `digitizer_trigger_coupling()'
- `digitizer_trigger_mode()'
- `digitizer_trigger_delay()'
- `digitizer_averaging()'
- `digitizer_num_averages()'
- `digitizer_record_length()'
- `digitizer_trigger_position()'
- `digitizer_meas_channel_ok()'
- `digitizer_start_acquisition()'
- `digitizer_get_curve()'
- `digitizer_get_area()'
- `digitizer_get_amplitude()'
- `digitizer_run()'
- `digitizer_copy_curve()'
|
|
|
|
|
This document was generated by Jens Thoms Toerring on September 6, 2017 using texi2html 1.82.