 |
 |
 |
 |
 |
 |
 |
 |
 |
B.65 Rohde & Schwarz SMB100A Signal Generator
Module name: rs_smb100a
Description: Rohde & Schwarz SMB100A series of Signal Generator (SMB-B101, SMB-B102, SMB-B103, SMB-B106, SMB-B112, SMB-B112L, SMB-B120, SMB-B120L, SMB-B140 and SMB-B140L) with support for output level normalization via frequency/amplitude table files.
Please note: according to the support at Rohde&Schwarz attenuation settings for frequencies below 200 kHz for devices with a lower RF linit frequency of 100 kHz (i.e. SMB-B112, SMB-B112L, SMB120, SMB-B120L, SMB-B140 and SMB-B140L) are not specified and thus may not be 100% reliable.
Controlled via: LAN (VXI-11 protocol)
Status: Untested
Supported functions:
- `synthesizer_name()'
- `synthesizer_state()'
- `synthesizer_frequency()'
- `synthesizer_attenuation()'
- `synthesizer_automatic_level_control()'
- `synthesizer_minimum_attenuation()'
- `synthesizer_use_table()'
- `synthesizer_att_ref_freq()'
- `synthesizer_mod_state()'
- `synthesizer_mod_type()'
- `synthesizer_mod_source()'
- `synthesizer_mod_freq()'
- `synthesizer_mod_ampl()'
- `synthesizer_mod_mode()'
- `synthesizer_setup_list()'
- `synthesizer_selected_list()'
- `synthesizer_start_list()'
- `synthesizer_stop_list()'
- `synthesizer_delete_list()'
- `synthesizer_show_lists()'
- `synthesizer_list_length()'
- `synthesizer_list_index()'
- `synthesizer_list_frequencies()'
- `synthesizer_list_powers()'
- `synthesizer_attenuation_offset()'
- `synthesizer_min_attenuation()'
- `synthesizer_max_attenuation()'
- `synthesizer_output_impedance()'
- `synthesizer_protection_tripped()'
- `synthesizer_reset_protection()'
- `synthesizer_rf_mode()'
- `synthesizer_rf_off_mode()'
- `synthesizer_mod_output_impedance()'
- `synthesizer_mod_output_voltage()'
|
|
|
|
|
This document was generated by Jens Thoms Toerring on September 6, 2017 using texi2html 1.82.